Project Source MT-25005L - SERVICE AND CLEANING PROCEDURES; Spray Tip Cleaning; Inlet Water Strainer Cleaning

SERVICE & CLEAN
1. TURN OFF WATER SUPPLY
2. REMOVE THE STRAINER
18
Spray Tip Cleaning and Servicing
• Press 'Nozzle Clean' button and water sprays out. Press the button again to extend the rear nozzle.
Then press again to extend the front nozzle. Clean the nozzles with a non-abrasive brush.
NOTE: Don't forcefully pull or bend spray tips.
1. When you find that flush water pressure is not
enough or decreases, clean the strainer.
2. Please turn off inlet water valve to stop water
supply.
3. Turn the angle valve handle counter-clockwise
to close the angle valve.
NOTE: It is forbidden to remove the strainer when
the inlet water valve is not closed, otherwise water
may spray out.
1. Remove the strainer cover with a flat-head screwdriver and pull it out together with the strainer
inside. Please refer to pictures for detailed operations.
A
x 1
Hardware Used
HH
Angle Valve
Parts Used
A
Toilet
Turn counter-clockwise of the strainer cover
x 1
HH
A
INLET WATER STRAINER CLEANING