CHARGING INSTRUCTIONS
STEP 1 – CHECK THE ELECTROLYTE LEVEL
Prior to charging the battery, remove the vent caps and check the electrolyte level (not
required on sealed & maintenance free batteries). The electrolyte should be 6mm (1/4”)
above the battery’s plates. If low, top up with distilled water to the correct level and
refit the vent caps.
STEP 2A – CONNECTION OUT OF THE VEHICLE
Connect the RED lead (battery clip) from the charger to the Positive (+) battery post.
Connect the BLACK lead (battery clip) from the charger to the Negative (-) battery post.
LITHIUM
GEL
AGM
WET
CALCIUM
PWR SUPPLY
1A
2A
4A
7A
IC7
12V 7A 7-STAGE
CHARGE
RATE
MODE
POWER ON
CHARGING
FULLY
CHARGED
INTELLI-CHARGE
12V
7A BATTERY CHARGER
Connection out of vehicle
9
To Next Page
Loading...
