Prolife PA3 Backlight - Memory Full; Memory: Cancellation of All Measurements; Memory: Storage and Recall of the Measurements

12
5.6. MEMORY: STORAGE AND RECALL OF THE MEASUREMENTS
The blood pressure monitor automatically stores each of the
last 120 measurement values. By pressing the MEMORY button,
an average value of the last 3 measurements (MR) as well as
the last measurement and the previous 119 measurements
can be displayed one after the other.
MR: average
value of the last
3 measurements
MR
9
: values
of the last
measurement
MR
8
–MR
7
:
values of the measurements before
5.7. MEMORY FULL
Pay attention that the maximum memory capacity
is not exceeded. When the memory is full, the old
values are automatically overwritten with new ones.
When memory is full, the display shown 1 second as
follows to remind you MEMORY FULL.
5.8. MEMORY: CANCELLATION OF ALL MEASUREMENTS
Before you delete all readings stored in the
memory, make sure you will not need refer
to the readings at a later date. You may keep
a self-monitoring diary and record data in
writing to provide additional information to
your doctor.
In order to delete all stored readings, depress
the MEMORY button for at least 5 seconds,
the display will show the symbol «CL» and
then release the button.
The symbol «CL» begins to blink. To permanently clear the memory, press the
MEMORY button while «CL» is flashing.
5 sec