8
5 PUTTING THE DIGITAL BLOOD PRESSURE
MONITOR INTO OPERATION
5.1. INSERTING THE BATTERIES
1. Insert the batteries (4 x size AAA 1.5V), thereby observing the indicated
polarity.
2. If the battery warning , icon appears in the display, the batteries
remain 20% power to warn user the batteries will be run out.
3. If the battery warning
, эicon appears in the display, the batteries are
empty and must be replaced by new ones.
ATTENTION!
After the battery warning
, icon appears, the device is blocked until
the batteries have been replaced.
Please use «AAA» Long–Life or Alkaline1.5 V Batteries.
The use of 1.2 V Accumulators is not recommended.
If the blood pressure monitor is left unused for long periods, please remove
the batteries from the device.
5.2. READING THE SET DATE
1. Please press the TIME button
and the date will be shown in the display.
5.3. SETTING THE TIME / DATE
This Digital Blood Pressure Monitor incorporates an integrated clock with date
display. This has the advantage, that at each measurement procedure, not only the
blood pressure values are stored, but also the exact moment of the measurement.
After new batteries have been inserted, the clock begins to run TIME 12:00 and
DATE 1–01.
You must then re–enter the date and current time. For this, please proceed
as follows.
1. Press the TIME button for at least 3 seconds firstly, user icon will blink. Then
press TIME button again the display now indicates the set year, during
which the four characters blink. The correct year can be entered by pressing
the MEMORY button.
TIME
DATE
To Next Page
Loading...