Prolife PA3 Backlight - Inserting the Batteries; Putting the Digital Blood Pressure Monitor into Operation; Reading the Set Date; User Selection;Setting the Time and Date

7
EN
4 PUTTING THE DIGITAL BLOOD PRESSURE
MONITOR INTO OPERATION
4.1. INSERTING THE BATTERIES
1. Insert the batteries ( 4 x size AA, 1.5 V ), thereby observing the indicated polarity .
2. If the battery warning icon
appears in the display, the batteries remain
20 % power to warn user the batteries will be run out.
3. If the battery warning icon
appears in the display, the batteries are
empty and must be replaced by new ones.
ATTENTION
After the battery warning icon
appears, the device is blocked until the
batteries have been replaced.
The use of 1.2 V Accumulators is not recommended.
If the blood pressure monitor is left unused for long periods, please remove
the batteries from the device.
4.2. READING THE SET DATE
Press the TIME button and the date will be shown in the display.
4.3. USER SELECTION / SETTING THE TIME AND DATE
USER SELECTION
This advanced blood pressure monitor allows you to track blood pressure
readings for 2 individuals independently (User 1, User 2).
Before measurement, make sure you set the unit for the intended user.
1. Press the TIME button for at least 3 seconds. The display now indicates the set
user, during which the set user blinks. Click the MEMORY button to select user
.
2. To confirm, press ON/OFF button.
NOTE: we suggest the first person to take their pressure
to be User 1.
3 sec