14
The measured readings indicated an unacceptable difference between
systolic and diastolic pressures.
Take another reading following directions carefully.
Contact you doctor if you continue to get unusual readings
The pressure is over 290 mm Hg
Other possible malfunctions and their elimination
If problems occur when using the device, the following points should be checked
and if necessary, the corresponding measures are to be taken:
Malfunction Remedy
The display remains
empty when the de-
vice is switched on al-
though the batteries
are in place
Check batteries for correct polarity and if necessary insert cor-
rectly
Check battery performance and replace if necessary
The device gives an
error message several
times in succession
or the measurement
values do not corre
-
spond to subjective
general
condition (too
high / low)
Check the positioning of the cuff
Measure the blood pressure again in peace and quiet under ob-
servance of the details made under point 5
The results of several
consecutive measure-
ments vary signifi-
cantly
Please read and understand «The most common causes of er-
rors» section. Repeat the measurement again, making sure all
the rules for its execution are followed.
Note: The blood pressure is a dynamic value and uctuates
continually, therefore, a minor dierence in values is accept-
able between consecutive measurements
Blood pressure mea-
sured differs from
those values mea-
sured by the doctor
Keep a self-monitoring diary and show it to your doctor at the
next visit.
Note: A patient may experience «white coat syndrome» at
the doctor’s appointment, so the pressure readings are high-
er than in a familiar home environment