ProLights ECLIPSEFS - Fixure Information; Reload Default

ECLIPSEFS
16
ton
• Press the button UP/DOWN to select Dimmer1 - Dimmer2 - Dimmer3 - Dimmer4.
• Press ENTER button to store.
• Press the MODE button to go back or to meet the waiting time to exit the setup menu.
Halogen
• You can set the Halogen mode thought this section.
• Press the button MODE to enter the menu mode.
• Press UP/DOWN button to select the ADVANCED. Press the ENTER button to conrm.
• Press UP/DOWN button to select the desired option and press the ENTER button to conrm:
- HB Mode - To set the HB mode (High Brightness Mode, with the maximum value of the colors)
- Studio Mode - To set a automatic white balance.
• Press ENTER button to store.
• Press the MODE button to go back or to meet the waiting time to exit the setup menu.
Calibration
Select this function to calibrate and adjust code and channel:
• Press the button MODE so many times until the display shows ADVANCED, then press the button ENTER.
• Press the UP/DOWN button to scroll through the menu, then select Calibration and press the ENTER
button.
• Enter the password “050”.
• Use the UP/DOWN button to select the option proposed (Code/CHxx) and press the ENTER button to
conrm the setting.
• Press the MODE button to go back and save changes.
3.14 FIXTURE INFORMATION
To view all the information on the device, proceed as follows:
• Press the button MODE so many times until the display shows INFORMATION, then press the button EN-
TER.
• Press the UP/DOWN button to scroll through the menu, then select one of the following information
and press the ENTER button to display it.
- Time Info. - Through the Time Info function you can display the operating time of the projector.
- Temperature - Through the Temperature function can be displayed the temperature of sensor.
- Software Version - Through Software Version function you can display the currently installed software
version.
• Press the MODE button to exit the menu.
3.15 RELOAD DEFAULT
Select this function to reload all info:
• Press the button MODE so many times until the display shows DEFAULT, then press the button ENTER.
• Use the UP/DOWN button to select the option proposed (Basic Reload/Program Reload/Private Reload/ All
Reload) and press the ENTER button to conrm the setting.
• Press the UP/DOWN button to select On or O, then press the ENTER button to conrm.
• Press the MODE button to go back or to meet the waiting time to exit the setup menu.