Storage
If you are not using the appliance for an extended period of time. After cleaning please:
Turn oò and unplug the appliance.
Make sure the water is completely drained.
Run the appliance on FAN mode for 12 hours in a warm room to dry it and prevent
mould.
Clean the ölter as described in the previous section.
Remove batteries from the remote control.
Cover the appliance and store it upright in a location where it will not receive direct
sunlight.
T
ROUBLESHOOTING
Problem Possible Cause Solution
Unit does not turn on
when pressing ON/OFF
button.
P1 Protection Code
Turn oò the unit, drain the water
and restart the unit.
In COOL mode: room
temperature is lower than the
set temperature.
Reset the temperature.
E0 EEPROM error Contact the service agents or a
similar qualiöed person for service.
Unit does not cool well.
The air ölter is blocked with
dust or animal hair.
Turn oò the unit and clean the
ölter.
Exhaust hose is not connected
or is blocked.
Turn oò the unit, disconnect the
hose, check for blockage and
reconnect the hose.
The unit is low on refrigerant. Call a service technician to inspect
the unit and top oò refrigerant.
Temperature setting is too high. Decrease the set temperature.
The windows and doors in
the room are open.
Make sure all windows and doors
are closed.
The room area is too large Check the cooling area.
There are heat sources inside the
room.
Remove the heat sources if
possible.
The unit is noisy and
vibrates too much.
The ground is not level. Place the unit on a øat, level
surface.
The air ölter is blocked with dust
or animal hair.
Turn oò the unit and clean the
ölter.
The unit makes a gurgling
sound.
This sound is caused by the øow
of refrigerant inside the unit.
This is normal.
EN
32
To Next Page
Loading...
