PROLiNK Hurricane 5200C - Software Configuration

PROLiNK Hurricane 5200C/5201 ADSL2+ Modem / Router
User Manual
Page 9 of 59
4 Software Configuration
When you switch ON the modem/router, the system will boot up and connect to ADSL
automatically. The system provides PVC for bridge test by default. These default
configurations for the system are listed as below.
z LAN IP address: 192.168.1.1 ; Net Mask: 255.255.255.0
z UART setting: 115200bps, 8 bits, no parity, 1 stop bit, no flow control.
z VPI/VCI for ATM: 0/35
z ADSL Line mode: Auto-detect.
You can change the settings via WEB browser. The following sections will describe the
set-up procedures.
Please configure your PC’s LAN port as followed:
z IP address: 192.168.1.xxx (e.g. 192.168.1.10)
z Net Mask: 255.255.255.0
Then, access the Web Console using the steps below:
z Start your web browser.
z Type the LAN IP address of the modem/router on the address bar of the browser. The
default IP address is 192.168.1.1.