Why is the PROLiNK Inverter backup time so short?
The backup time of your PROLiNK Inverter might be short due to several reasons: overloading, in which case you should disconnect non-critical loads; low battery voltage, so you should recharge the battery for at least 8 hours; or a bad battery, which means you should replace it with a good quality battery.
What to do if the PROLiNK IPS has no LCD display?
If your PROLiNK Inverter's LCD display is not working, it could be due to a few reasons. The battery voltage might be low, so recharge the battery and check the battery cables are well connected. The battery could also be defective, requiring replacement. Finally, ensure you press and hold the power button.
General| Model | IPS Series |
|---|---|
| Category | Inverter |
| Input Voltage | 12V / 24V / 48V DC |
| Output Waveform | Pure Sine Wave |
| Output Frequency | 50Hz / 60Hz |
| Protection Features | Overload, Over Temperature, Short Circuit |
| Cooling | Fan |
| Operating Temperature | 0°C to 40°C |
To Next Page
