Installation
3
English
EN2
Batteries
Determine the size of battery
The inverter is designed with pre-set charging current and voltage. Given a fixed charging
current, under-sized batteries may shorten the battery life while over-sized batteries may
result in unreasonable recharging time. It is recommended that the batteries capacity shall
be no less than 100AH.
Safety Clearance
The minimum clearance to the wall shall be larger than 30cm in order to ensure proper
ventilation. In the event the ambient temperature is high, it’s recommended to increase
the distance of safety clearance to improve the heat dissipation.
Mounting Inverter on the wall
The inverter is designed to either be placed on horizontal surface or be mounted on the
wall (as shown below). When mounting the inverter on the wall:
1. The wall shall be solid and strong enough to carry the inverter;
2. The location of installation shall allow the user to read the LCD easily;
3. Two screws shall be firstly fixed on the wall (distance as shown below) so that the inverter
can be hung on the screws, recommended screw size is M4*50~65mm.
4. After mounting the inverter, make sure it’s firmly mounted and won’t easily fall off in the
event of unexpected earthquake or vibration.
30cm30cm
30cm
30cm
To Next Page
Loading...