ASSEMBLING YOUR VACUUM
Once all items have been removed from the shipping box first INSERT THE HEPA DUST
BAG BEFORE USING
Important: For best results do not use the vacuum without all filters, cloth dust bag, and the
HEPA dust bag in place.
NOTE: This model can be used with the cloth dust bag only, however it is not recommended and MUST BE
cleaned after every use if no HEPA bag is installed to assure proper air flow.
1. Turn off the power with the switch and remove the flexible hose if attached.
2. To open the canister lid press on the canister lid tabs on each side of the unit and lift the
canister lid. (Fig.1)
3. Pull the tab on the HEPA dust bag holder out slightly and flip upwards. (Fig 2)
4. While holding the HEPA dust bag in your hand, slide it firmly between the slots in the bag
holder. (Fig 2)
5. The cardboard face of the new bag should rest securely in the dust bag cover guide. (Fig 3)
6. Ensure that the cloth bag is in place. (Fig. 4)
7. Flip the patented HEPA bag holder over, pressing the tab on the bag holder until it clicks
then replace the canister lid.
To Next Page
Loading...
