Promag TR515 - Table of Contents; Attention! Firmware Management Mode (FMM)

Attention! Firmware Management mode (FMM)
The TR515 has two different modes of operation. Normal mode provides
regular device functionality. Firmware Management mode (FMM) is provided for
internal firmware checkup and upgrades (see Section 5).
The Normal mode is entered by powering the TR515 up while
not
pressing
the IN button. Switching the TR515 on while holding the IN button or both IN
and OUT buttons down forces the unit into the FMM. The FMM mode of
operation cannot be exited other than by switching the TR515 off and back on
again.
Contents
Attention! Firmware Management mode (FMM)..................
Contents...............................................................................
1. Installing the TR515 ....................................................... 1
2. Using the TR515 ............................................................ 7
3. Communications protocol .............................................. 8
4. Registers...................................................................... 16
5. Firmware Management mode...................................... 20
6. Test mode.................................................................... 23
Appendix A. Possible Errors ............................................ 25
Appendix B. Interface connector pin assignment............. 25
Appendix C. Cable ........................................................... 26
Appendix D. Specifications .............................................. 28
Appendix E. Ordering Information.................................... 28
Appendix F. Software Installation …………………………29