Need help?Do you have a question about the Promag TR515 and is the answer not in the manual?
General| Brand | Promag |
|---|---|
| Model | TR515 |
| Category | Measuring Instruments |
| Language | English |
Describes how the TR515 can be used as a wall-mount or desktop device.
Details the RS232 and RS485 interface options for communication.
Details the TR515EX's Ethernet connectivity and cable types.
Describes the TR515WX's wireless operation and master station requirement.
Explains the concept and use of machine numbers for terminal identification.
Details the procedure for assigning unique machine numbers to terminals.
Describes the built-in bell relay and its scheduling capabilities.
Explains how to fix event selection (IN/OUT) for specific use cases.
Instructions for registering IN/OUT events using ID cards.
Indicates what happens when the device's memory is full.
Describes how the TR515 detects and notifies about errors.
Details the GNET protocol specification and communication parameters (19200-8-N-1).
Explains the structure of command and reply data packets, including STX, CR, and checksum.
Lists supported commands, their hex codes, checksum requirements, and potential errors.
Details the 'D' command for selecting a specific terminal on the network.
Command to assign a new machine number to a terminal.
Command to retrieve a terminal's machine number.
Command to set the TR515's internal clock date and time.
Command to retrieve the TR515's current date and time.
Command to verify the TR515's internal firmware version.
Command to restore factory defaults and initialize the terminal.
Command to set TR515 functioning parameters (registers).
Command to retrieve data stored in a designated register.
Command to retrieve the count of records in the database.
Command to retrieve a specific record from the database by number.
Command to initialize (clear) the TR515 database.
Command to alter the database for recovery purposes.
Command to initiate a hardware test mode.
Details setting and getting the LED display mode (wall-mount/desktop).
Details setting and getting the bell duration in seconds.
Details setting and getting bell times for external bell control.
Details setting and getting the enable/disable state for bell table entries.
Details setting the event selection mode (free, IN only, OUT only).
Procedure to upgrade the TR515's internal firmware using a PC.
Step-by-step guide for firmware download and common error messages.
Procedure to check the validity of the currently loaded firmware.
How to initiate test mode and important warnings about data loss.
Describes the automated and manual test phases and expected results.
Lists error messages and remedies for normal operation of TR515.
Details the pin assignments for the Ethernet interface connector.
Details pin assignments for Wireless, RS232, and RS485 interface connectors.
Wiring details for the WAS-1436 cable used with RS-232 interfaces.
Wiring details for the WAS-1467 cable used with RS-485 interfaces.
Wiring details for the WAS-1498 Ethernet cable to PC.
Wiring details for the WAS-1499 Ethernet cable to a hub.
Lists key specifications including display, card readers, capacity, and interfaces.
Details physical dimensions, power supply, operating temperature, and humidity.
Lists TR515 models with Ethernet interface and their card reader types.
Lists TR515 models with Wireless interface and their card reader types.
Lists TR515 models with RS-232/485 interface and their card reader types.
Step-by-step guide for installing software and configuring Ethernet connection via hub.
Guide for PC to TR515 Ethernet connection using WAS-1498 cable.
Details on password, IP address, routing mode, serial settings, and application program connection.
Guide for setting up the TR515 with a wireless interface using the application program.
Instructions for assigning unique IDs and configuring the wireless connection.
To Next Page