277
Chapter 9: Troubleshooting
This chapter covers the following topics:
• VessRAID is Beeping (below)
• LEDs Display Amber or Red (page 278)
• CLU Reports a Problem (page 282)
• WebPAM PROe Reports a Problem (page 284)
• LCD Panel Reports a Problem (page 287)
• Viewing a Report from OPAS (page 287)
• Event Notification Response (page 289)
• Critical & Offline Disk Arrays (page 302)
• Incomplete Array (page 305)
• Physical Drive Problems (page 306)
• Enclosure Problems (page 308)
• Connection Problems (page 311)
• Browser Does Not Connect to WebPAM PROe (page 314)
• Unsaved Data in the Controller Cache (page 316)
VessRAID is Beeping
VessRAID’s alarm has five different patterns, as shown below.
Figure 1. Audible alarm sound patterns
When you first power-up the VessRAID, it beeps twice to show normal operation.
The audible alarm sounds at other times to inform you that the VessRAID needs
attention. But the alarm does not specify the condition. When the alarm sounds:
• Check the front and back of VessRAID for red or amber LEDs, as described
above.
.25s.25s.25s
.25s.25s
.25s.25s
.25s.25s .25s
.25s
.25s
.5s
.25s
.5s
.75s
.25s
.75s
.25s
.75s
1s 1.25s
2.5s
3s
1x
2x
1
2
3
4
5
6s
s
8
To Next Page
Loading...
Need help?
General
