Rage – specification
PROPAIN’s Rage is a Downhill Bike. Please find the according cat-
egory in the “user handbook bicycles” which is included in your bike
delivery. Be sure to use your bicycle only according to the “intended
use” specified by the category.
If you replace parts of your bicycle, please pay special attention to
the hardware compatibility. If in doubt, please contact Propain or
your local bike dealer.
The Rage has the following specifications:
Maximum front travel allowed: 203mm
Rear travel: 220mm
Shock length: 241mm
Shock travel: 76mm
Shock mount top and bottom (both sides): 22,2mm x 8mm
Bottom bracket: 83mm BSA
Break mount: Post Mount 160
Seat post diameter: 31,6mm
Headset (S.H.I.S.): Tapered: Top: ZS44 /
Bottom: ZS56
Rear wheel axle: 157mm Syntace X12
Rear hub width: 157mm
Chain line: 56,5mm
Chain guide mount: ISCG05
Recommended tire size: 650B (27,5“)
Tightening torque
The mounting bolts of the frame and suspension have to be tight-
ened according to the table below. After untightening any bolts
Propain recommends using Loctite 243 (medium) before tightening
the bolts again. Please also consider the drying time of Loctite.
Suspension
To Next Page
Loading...
