EasyManua.ls Logo

Prorelax SUPER DUO - Page 29

Prorelax SUPER DUO
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
29
Portable and mobile RF communica-
tionsequipmentshouldbeusedno
closertoanypartoftheTENS+EMS
SUPER DUO , including cables,than the
recommended separation distance
calculatedfromtheequation
applicabletothefrequencyofthe
transmitter. Recommended separation
distance
where P is the maximum output power
rating of the transmitter in watts (W)
according to the transmitter
manufacturer and d is the
recommended separation Distance in
metres (m).
Field strengths from xed RF
transmitters, as determined by an
electromagnetic site survey, a should
be less than the compliance level in
eachfrequencyrange.b
Interference may occur in the vicinity
ofequipmentmarkedwiththe
following symbol:
Technical Specications
Vorgaben und Herstellererklärung – Elektromagnetische Immunität
Immunity test
Conducted RF
IEC 61000-4-6
Radiated RF
IEC 61000-4-3
IEC 60601
test level
3 Vrms
150kHzto
80MHz
3 V/m
80MHzto
2,5GHz
Not applicable
3 V/m
Compliance
Level
Electromagnetic environment –
guidance
TheTENS+EMSSUPERDUOisintendedforuseintheelectromagneticenvironment
speciedbelow.ThecustomerortheuseroftheTENS+EMSSUPERDUOshouldassure
that it is used in such an environment.
a.Field strengths from xed transmitters, such as base stations for radio (cellular/cordless)
telephonesandlandmobileradios,amateurradio,AMandFMradiobroadcastandTVbroadcast
cannot be predicted theoretically with accuracy. To assess the electromagnetic environment due
to xed RF transmitters, an electromagnetic site survey should be considered. If the measured eld
strengthinthelocationinwhichtheTENS+EMSSUPERDUOisusedexceedstheapplicableRF
compliancelevelabove,theTENS+EMSSUPERDUOshouldbeobservedtoverifynormal
operation. If abnormal performance is observed, additional measures may be necessary, such
asre-orientingorrelocatingtheTENS+EMSSUPERDUO
b.Overthefrequencyrange150kHzto80MHz,eldstrengthsshouldbelessthan3V/m.
NOTE1At80MHzand800MHz,thehigherfrequencyrangeapplies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is aected
byabsorptionandreectionfromstructures,objectsandpeople.