Proscend 6200-2W - Web Configuration

13
3
3
.
.
1
1
.
.
2
2
.
.
S
S
e
e
r
r
i
i
a
a
l
l
C
C
o
o
n
n
s
s
o
o
l
l
e
e
C
C
o
o
n
n
f
f
i
i
g
g
u
u
r
r
a
a
t
t
i
i
o
o
n
n
The console port is a RJ-45 connector that enables a connection to a PC for monitoring and configuring the VPN Router.
Use the supplied serial cable with a female DB-9 connector to serial port of PC and RJ-45 module jack connector to
VPN Router’s console port. Start your terminal access program by terminal emulation program or Hyper Terminal
and configure its communication parameters to match the following default characteristics of the console port:
Parameter Value
Baud Rate 115200
Data Bits 8
Parity Check None
Stop Bits 1
Flow Control None
It will ask for user name and password in order to remote login when using telnet, please use “root” for username and
“root” for password. Please check the following screen shot for what you will see in your terminal window.
3
3
.
.
1
1
.
.
3
3
.
.
T
T
e
e
l
l
n
n
e
e
t
t
C
C
o
o
n
n
f
f
i
i
g
g
u
u
r
r
a
a
t
t
i
i
o
o
n
n
The VPN Router also supports telnet for remote management. Please make sure the correct Ethernet cable
connected the LAN ports of device to your computer. The LAN indicator on the front panel shall light on if a correct
cable is used. Start your telnet client with a command window or VT100 terminal emulation by key in “192.168.0.1”,
which is the management IP address of 6200 series VPN router, and wait for the login page prompts up. Then, key
in the user name and the password once the login page shows. The login page is shown as the following screen shot.
(The default user name and password are “root” and “root”.)