1
• SUMMARIZE
The meter is a stable multimeter with 25mm LCD display, driv-
en by battery. It’s widely used on measuring DCV, ACV, DCA,
ACA, resistance, capacitance, diode, transistor, continuity test
and temperature. It’s an ideal tool for lab, factory and family.
• SAFETY NOTE
The meter meets the standards of IEC1010. Read the opera-
tion manual carefully before operation.
1. Do not input limit over-ranged.
2. The voltage below 36V is safety. To avoid electric shock,
check whether the test leads are connected correctly,
whether the insulation is good when measuring over 36DCV
or 25ACV.
3. Remove the test leads when changing function and range.
4. To select correct function and range, beware of error
operation.
5. Do not operate the meter if battery case and back cover is
not xed.
6. Do not input voltage when measuring resistance.
7. Remove test leads from test point and turn off the power
before replacing battery and fuse.
8. SAFETY SYMBOLS
“
” EXISTS DANGEROUS VOLTAGE,“ ”
GND,“
” DUAL INSULATION
“
”THE OPERATOR MUST REFER TO THE
MANUAL,“
” LOW BATTERY
To Next Page
Loading...
