Unpacking and Inspection
Carefully unpack the unit. If it appears damaged in any way, return it to the dealer it was purchased from
in its original packaging. Maplin cannot accept any responsibility for damage arising from the use of non-
approved packaging.
Service
All ProSound products are thoughly examined and tested before leaving the factory, and if a correctly used
will give many years of excellent service. However, if a problem arises, proceed as follows:
A) Contact the retailer from whom the unit was purchased and describe the symptoms of the fault.
B) If the retailer cannot help, return the equipment to the national distributor for your country. Use the
original packaging to protect the product from damage. Include a note with the equipment stating
your name and address, details of the problem, Date Code, date and place of purchase.
The unit does not contain any user serviceable parts. For details of spares, accessories and other
products, contact you local retailer. In the event of any difficulty contact ProSound directly via
www.maplin.co.uk
Compliance
This equipment is designed to comply with the following standards:
BS EN55103-1:1996
BS EN55103-2:1997
BS EN60065:2002
Malin Electronics constantly seeks ways to enhance our products, and improvements take place continu-
ally. Whilst every effort is made to produce up to date literature, Malin Electronics limited reserve the right
to alter specifications without prior notice.
- 9 -
Check mains connections, check switch set to ‘on’ (at socket & amp),
check mains breaker or RCD, replace fuse (See manual for
IMPORTANT SAFETY INFORMATION)
Outputs short circuit, or low
impedance load
Check all output connections and total speaker impedance. For stereo
mode, minimum 4 per channel, for bridge mode minimum 8 . When
problem is cleared press RESET button. DO NOT ATTEMPT TO
HOLD THE RESET BUTTON IN TO DEFEAT ITS PURPOSE !
Ensure vents are clear, with free airflow front & rear. Ensure signal is
not clipped at amp input or source output. Amp will resume normal
operation after 3-5 minutes.
Amp is in bridge mode with
stereo outputs in use
Use bridge output only (minimum 8 ) in bridge mode
IF YOUR AMP STOPS WORKING ;
• Turn volume to zero on both channels
• Check all connections (input and output, at both ends of cable)
• Check status lights on front panel
• Disconnect from mains before changing fuse
• Replace fuse only with same type and rating
• If problems persist contact a qualified service agent
• READ THE MANUAL !
.
At the end of its serviceable life, this product should not be treated as household or general waste. It should be
handed over to the applicable collection point for the recycling of electrical and electronic equipment, or returned
to the supplier for disposal.
1. All electrical and electronic equipment without batteries
WEEE Directive & Product Disposal
This symbol on the battery indicates that the battery is to be collected separately.This battery is designed for
separate collection at an appropriate collection point.
2. electrical and electronic equipment that are supplied
with batteries (including internal batteries)
WEEE Directive & Product Disposal
Internal / Supplied Batteries
At the end of its serviceable life, this product should not be treated as household or general waste. It should be
handed over to the applicable collection point for the recycling of electrical and electronic equipment, or
returned to the supplier for disposal.
3. Batteries
Notice to customers
This symbol on the battery indicates that the battery is to be collected separately.
The following apply only to users in European countries.
This battery is designed for separate collection at an appropriate collection point. Do not dispose of as household
waste.
For more information, contact the retailer or local authorities in charge of waste management.
To Next Page
Loading...