User Manual 26
AC Power Monitor
The AC Power Monitor feature is enabled in the Installer Settings
(See Installer Manual). If enabled, this feature will automatically be present.
If your thermostat was hardwired (power provided from the system with batteries
as a backup) then the AC Power Monitor feature will indicate when a loss of
power to the thermostat has occurred by displaying NO POWR.
Indoor Remote Sensing
Indoor remote sensing is achieved by installing a remote indoor sensor and is configured in the Installer
Settings (See Installer Manual). If an indoor remote sensor was installed and properly configured in the Installer
Settings, the thermostat will sense temperature at a remote location or at a combination of a remote location and
the thermostat location.
Outdoor Remote Sensing
Outdoor remote sensing is enabled by installing
a remote outdoor sensor. No additional
configuration is required.
If an outdoor remote sensor was installed
you may press the PROG and HOLD buttons at the
same time to view the outdoor temperature.
To Next Page
Loading...
