EasyManua.ls Logo

ProTeam ProForce 1500XP - Understanding Your Vacuums Basics; Indicator Lights Explained; On;Off Switch Operation; Lowering the Handle

ProTeam ProForce 1500XP
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6
english
indicator lights
The panel on the front of the
vacuum contains the indicators
listed below: (A)
bag full
Indicator is lit when Intercept
Micro Filter should be changed.
power nozzle on
Indicator is lit when power nozzle
is turned on.
jammed brush roll
Indicator is lit when brush roll is
jammed.
reset switch
Press red reset switch to restart
motor after clearing a blockage.
(B)
on/off switch
Make sure the vacuum is plugged
in to a 3-prong outlet, then press
the Off/On switch to start or stop
the vacuum. (C)
The switch positions are:
I = Vacuum Motor On
O = Off
II = Power Nozzle and
Vacuum Motor On
lowering the handle
Place foot on base cover and pull
handle toward you. (D)
electrical cord care
CAUTION: Leave slack in the
cord while vacuuming. (E)
DO NOT stretch the cord
tightly between the vacuum
and electrical outlet.
RELEASE CORD. Turn cord
storage release and place in
the down position to release
cord. (F)
REWIND CORD FOR
STORAGE. Turn the cord
storage release and place in
the up position. Wind cord
around lower cord holder
and cord storage release. (G)
To avoid damaging the
power cord and strain relief,
always wrap powercord
counter-clockwise around the
top and bottom cord wraps.
D
A
B
C
español
luces indicadoras
El panel de la parte frontal de la aspi-
radora contiene los siguientes indi-
cadores: (A)
bolsa llena
Este indicador se enciende cuando se
debe cambiar la bolsa.
boquilla de succión ancha encen-
dida
Este indicador se enciende cuando la
boquilla de succión ancha está en fun-
cionamiento.
obstrucción en el rodillo del cepillo
Este indicador se enciende cuando el
rodillo del cepillo está obstruido.
interruptor de reinicio
Presione rojo el interruptor automático
del circuito para
reiniciar el motor después de limpiar un
atasco u obstrucción. (B)
interruptor de encendido/
apagado
Revise que la aspiradora esté conectada
a un tomacorriente de tres puntas,
luego presione el interruptor de encen-
dido/
apagado para encender o detener la
aspiradora. (C)
Las posiciones del interruptor son:
O = Apagado
I = Motor de la aspiradora
encendido
II = Motores de la
aspiradora y de la
boquilla de succión
ancha encendidos
bajar
la manija
Coloque el pie en la cubierta de la base
y hale la manija hacia usted. (D)
cuidado del cable eléctrico
ADVERTENCIA: Permita que el
cable no qued tensionado al aspi-
rar. (E)
NO tensione el cable entre la aspi-
radora y el tomacorriente.
SOLTAR EL CABLE. Voltee el
soporte para colocar el cable hacia
abajo para poder soltar el cable. (F
ENROLLAR EL CABLE. Voltee el
soporte para colocar el cable hacia
arriba. Enrolle el cable alrededor
del soporte. (G)
• Para evitar daños en el sujetador
de cable, envuelva siempre el
cable en sentido opuesto a las
manecillas del reloj alrededor de la
parte superior e inferior de la
cubierta del cable.
1500XP
basics
R
E
S
E
T
R
E
S
E
T
E
F
G

Other manuals for ProTeam ProForce 1500XP

Related product manuals