Why is my protech EVO COMPACT Construction Equipment overheating?
If your Protech Construction Equipment is overheating, it could be due to a lack of oil or brakes binding. First, try adding oil. If the issue persists, check the brake release pressure.
What to do if motor runs but drive sprocket not turning on Protech Construction Equipment?
If the motor runs but the drive sprocket isn't turning on your Protech Construction Equipment, this could be due to an internal malfunction or a jammed brake. In that case you should check the brake release pressure.
Why is my protech EVO COMPACT leaking oil?
If you notice oil leakage in your Protech Construction Equipment, it may be due to hardened, damaged, or worn seals. Begin by cleaning around the component and rechecking it after a few days to monitor the leak's severity.
What to do if track jams when steering the protech EVO COMPACT Construction Equipment?
If the track on your Protech Construction Equipment jams when steering, it's likely due to material such as stones, rocks, or earth trapped between the rollers, drive sprocket, and tensioner. Remove the trapped material by turning the track in both directions. If possible, raise the machine while doing this.
How to fix track damage on protech EVO COMPACT?
If the track on your Protech Construction Equipment is damaged, showing excessive tread wear or a loosening/breaking of the internal structure, the suggested solution is to replace the track.
Why does the track slacken frequently on protech EVO COMPACT Construction Equipment?
If the track on your Protech Construction Equipment slackens frequently, it could be due to a faulty tensioner valve or worn tensioner components. Replace the valve or replace the worn components.
Why does upper track not stay in position on Protech Construction Equipment?
If the upper track on your Protech Construction Equipment does not stay in position, it's likely due to worn upper track rollers. Replace the track rollers.
Why does lower track not stay in position on Protech Construction Equipment?
If the lower track on your Protech Construction Equipment does not stay in position, it's likely due to worn lower track rollers. Replace the track rollers.
Lists the standard features and specifications for the EVO COMPACT model.
Details the standard features and specifications for the EVO1S model.
Outlines the standard features and specifications for the EVO 2S model.
Explains the operation of the slew arm control lever for pivoting the arm.
Describes the operation of the telescopic arm control lever.
Explains the operation of the rear leg control lever for stability.
Details the operation of the mast forward tilt control lever.
Describes the operation of the mast side tilt control lever.
Explains how to operate the driver weight control.
Details the operation of the track extension control for wider footprint.
Controls the left side hydraulic motor for forward and reverse track movement.
Controls the right side hydraulic motor for forward and reverse track movement.
Explains the speed control for the auger motor.
Describes the one-push button system for aligning the mast to the vertical position.
Provides instructions for re-calibrating the auto-level system.
Introduces the Scanreco radio control transmitter and its integrated options.
Identifies and describes the various switches and controls on the panel.
Details the junction box layout and its associated relays and fuses.
Lists daily and weekly checks, greasing, and inspection tasks.
Outlines essential monthly checks and tightening procedures.
Details annual maintenance tasks including fluid and filter replacements.
Provides instructions on how to check and adjust the track tension.
Lists the recommended lubricants for various machine parts.
Provides guidance on Yanmar engine servicing intervals and oil specifications.
General| Brand | protech |
|---|---|
| Model | EVO COMPACT |
| Category | Construction Equipment |
| Language | English |
To Next Page
