Protect ERA - Page 8

INSTALLING YOUR KEYPAD
Insert the batteries into the back
of the keypad.
Connect the front of the keypad
to the backplate.
Once you have inserted the
batteries, connect the keypad
to the backplate.
Re-insert the screw into the
bottom of the keypad and tighten.
5
7
6
8
+
+
AAA
+
+
+
Note: The keypad tamper is disabled for 15 minutes after power up.
If the keypad is not connected to the backplate within 15 minutes,
then your alarm will be triggered. You can reset the timer by disconnecting
and reconnecting the batteries.
Page 8