STEP 1: ASSEMBLE STABILIZERS
a. ATTACH FRONT STABILIZER ( 02 )
TO THE MAIN FRAME ( 01 ) WITH
CARRIAGE BOLTS ( 27 ),
WASHERS ( 29 ) & DOME NUTS
( 33 ). THEN FULLY TIGHTEN THEM
WITH SPANNER.
b. ATTACH REAR STABILIZER ( 03 )
TO MAIN FRAME ( 01 ). FASTEN
WITH BOLTS ( 30 ), WASHERS ( 29 )
& DOME NUTS ( 33 ). THEN FULLY
TIGHTEN THEM WITH SPANNER.
NOTE : TO PREVENT DOME NUT ( 33 ) FROM
DAMAGING FLOOR, THE BOLT ( 27 )
& BOLT ( 30 ) MUST INSERT FROM
THE BOTTOM TO THE TOP.
STEP 2: ASSEMBLE PEDALS
a. ATTACH RIGHT PEDAL ( 18 ) TO
RIGHT CRANK ( 7R ), FULLY
TIGHTEN CLOCKWISE WITH
SPANNER.
b. ATTACH LEFT PEDAL ( 19 ) TO
LEFT CRANK ( 7L ), FULLY
TIGHTEN COUNTERCLOCKWISE
WITH SPANNER.
STEP 3: ASSEMBLE SADDLE & SEAT POST
a. ATTACH SADDLE ( 20 ) TO SADDLE
PLATE OF SLIDING TUBE ( 4b ).
FASTEN IT WITH WASHERS ( 31 )
AND NYLON NUTS ( 32 ). FULLY
TIGHTEN WITH SPANNER.
b. SLIDE THE SLIDING TUBE ( 4b )
INTO SEAT POST ( 4a ) AND
SECURE WITH KNOB ( 4c ), THEN
ATTACH SEAT POST ( 4a ) TO MAIN
FRAME ( 01 ).
c. ADJUST SADDLE ( 20 ) TO
DESIRED HEIGHT, TIGHTEN WITH
KNOB ( 26 ).
d. TO RELEASE THE KNOB ( 4c ) TO
ADJUST THE SADDLE ( 20 ) BACK
AND FORTH AT YOU DESIRED
POSITION. THEN FASTEN THE
KNOB ( 4c ).
- 4 -
ASSEMBLY
STEP 1
29
33
2
27
1
33
29
3
30
STEP 2
19
7R
18
STEP 3
20
4d
4c
4a
4b
26
32
31
1
IMPORTANT : READ STEP 2 BEFORE
ASSEMBLE PEDALS.
To Next Page
Loading...
