How to fix Protocol Quadcopter Dronium Two AP that does not respond?
To synchronize your Protocol Dronium Two AP, first turn on the aircraft and place it on level ground. Then, turn on the controller. Also, make sure that the battery power is sufficient in both the aircraft and the controller. Charge the aircraft if needed, and replace the batteries in the controller.
What to do if Protocol Quadcopter Dronium Two AP will not hover or strafe correctly?
If your Protocol Dronium Two AP is not hovering or strafing correctly, it may be due to incorrect synchronization or trim settings. Try re-synchronizing the aircraft and controller, ensuring the aircraft is on level ground during synchronization. Additionally, reset the trim buttons on the controller and re-trim the flight controls.
General| Max Speed | Unknown |
|---|---|
| GPS Mode | GPS/GLONASS |
| Remote Controller Range | 7 km (FCC), 4 km (CE) |
| Battery | Intelligent Flight Battery |
| Flight Time | 30 minutes |
| Controller Range | 7 km (FCC), 4 km (CE) |
General warnings for safe operation and maintenance of the drone.
Instructions for attaching protective guards and landing gear to the drone.
Guidance for new pilots to learn basic flight maneuvers safely.
Common issues and their potential causes and solutions for the drone.
To Next Page
