Proton SL mini Series - Equipment Covered

Page 4 of 85
SL mini and SLR mini-i4 Series Speed and Length Gauges Instruction Manual - issue 3h
DECLARATION OF CONFORMITY (CE)
Manufacturer’s name: Proton Products International Ltd
Manufacturer’s address: 10 Aylesbury End
Beaconsfield
Bucks, UK
EMC Standards Applied: EN 61326-1:2013
Low Voltage Standards Applied: EN61010-1 2010 (Scientific and measuring instruments)
Laser used is 658Nm maximum power output for each beam 20mW (two are emitted from a single
source).
Laser Safety Compliance to: BS EN 60825-1:2007
Limitations to use: Heavy Industrial Environment
Compliance with EMC directives was by the standards route.
It is declared for and on behalf of Proton Products Ltd that the equipment specified below conforms to
EC directives EMC: 2014/30/EU and Low Voltage: 2014/35/EU and Laser Safety BS EN 60825-
1:2007.
Equipment Covered
Product name
Description
Part number
SL mini 1220 i4
Unidirectional non-contact speed and length gauge
(stand-off distance: 120mm, depth-of field: 20mm)
00060MC001
SL mini 3060 i4
Unidirectional non-contact speed and length gauge
(stand-off distance: 300mm, depth-of field: 60mm)
00060MC002
SLR mini 1220 i4
Bidirectional non-contact speed and length gauge (stand-
off distance: 120mm, depth-of field: 20mm)
00060MC005
SLR mini 3060 i4
Bidirectional non-contact speed and length gauge (stand-
off distance: 300mm, depth-of field: 60mm)
00060MC006
PSU-BOB i4
Break out box for the 25 pin terminal strip on the gauge
head combined with power supply
00060MC050
SiDi-CDi4
Touch screen display module
00049MC021
These products carry the CE Mark:
The manufacturer of the above named equipment is:
Proton Products International Limited
10 Aylesbury End
Beaconsfield
Bucks
HP9 1LW
ENGLAND
Proton Products is an ISO9001:2015 registered company.
The declaration is signed by:
Paul Sives ………………………