16
GB
Renovation Cutter
RGP 150-16 E –
original instruction
Table of contents
1 Symbols ................................... 16
2 Technical data ........................... 16
3 Prescribed usage ........................ 16
4 Control Elements ....................... 17
5 Notes on Safety Prevention ......... 17
5.1 General Safety Instructions ......... 17
5.2 Safety instructions for all work
activities ................................... 17
5.3 Additional safety instructions
for all types of works .................. 18
5.4 Supplementary safety instructions
for grinding and cutting .............. 19
5.5 Additional safety instructions
for surface grinding .................... 19
5.6 Additional safety instructions
for grinding with wire brush ......... 20
5.7 Turner safety instructions ............ 20
5.8 Emission levels .......................... 20
6 Activation ................................. 21
6.1 Switching on and off ................... 21
6.2 Motor electronics ....................... 21
7 Usage ....................................... 21
7.1 Selection of the tool head ............ 21
7.2 Tool head change ....................... 21
7.3 Inserting tool head ..................... 22
7.4 Removing tool head .................... 22
7.5 Adjusting material removal depth .. 22
7.6 Changing tools .......................... 22
7.7 Dust extraction .......................... 23
7.8 Balancer ................................... 23
7.9 Surface guidance system
BG-RGP 150 .............................. 23
8 Work instructions ....................... 23
9 Maintenance .............................. 23
10 Environmental Protection /
Disposal.................................... 24
11 Warranty .................................. 24
12 Declaration of Conformity ............ 24
13 Selection of the tool head – table ... 25
1 Symbols
Double insulation
Warning of general danger
Risk of electric shock
Use protective goggles!
Wear ear protection!
Use protective gloves!
Read the instructions
Not to be included in municipal refuse
► Advice or tip
2 Technical data
Nominal voltage 230 – 240 V ~
Mains frequency 50 – 60 Hz
Power input 1600 W
Speed under load 1000 – 2200 rpm
Tool diameter 150 mm
Weight 5.9 kg
Protection class II /
3 Prescribed usage
The grinder is designed for the removal of
plaster, screed, tiles and remains of car-
pet adhesive from concrete surfaces, the
removal of shuttering projections and for
fl attening screed surfaces in the building
trade.
The grinder must only be used for dry
processing and combined with a powerful
extraction system.
The user shall be liable for any damage
resulting from non-specifi ed use.
To Next Page
Loading...
Need help?
General
