Tsunami MP-8100 Installation and Management Guide 124
4.10.1.1 Adding Static Route Entries
To add Static Route entries
1. Click Add in the Static Route Table screen. The Static Route Table Add Row screen is displayed as shown below.
Figure 4-63 Static Route Table Add Row
2. After adding the entry into the Static Route table, click Add.
3. Click COMMIT for the changes to take effect.
NOTE:
• Maximum 256 entries can be added to the static route table.
• While adding a new entry, the IP address of the Next Hop must be on the subnet of one of the device’s network
interfaces.
4.10.2 NAT (SU, Routing Mode Only)
The NAT (Network Address Translation) feature allows hosts on the Ethernet side of the SU to transparently access the public
network through the BSU. All the hosts in the private network can have simultaneous access to the public network.
The SU supports NAPT (Network Address Port Translation) where all private IP addresses are mapped to a single public IP
address and does not support Basic NAT (where private IP addresses are mapped to a pool of public IP addresses).
Both dynamic mapping (allowing private hosts to access hosts in the public network) and static mapping (allowing public
hosts to access hosts in the private network) are supported.
Entry Status This parameter is used to configure the status of the
static route. Only enabled routes are considered for
routing the packets.
Parameter Description
To Next Page
Loading...