Tsunami MP-8100 Installation and Management Guide 48
4.3 Ethernet Properties Configuration
In the Ethernet Interface Properties screen, you can configure the Ethernet transmission properties. The recommended
settings are Auto for TxMode And Speed. The device supports two ethernet interfaces Ethernet 1 and Ethernet 2.
To configure the Ethernet Interface
1. Click ADVANCED CONFIGURATION > Ethernet. The Ethernet Interface Properties screen is displayed as shown
below.
Figure 4-4 Wireless Ethernet Properties
2. Enter the appropriate parameters in the Ethernet Interface Properties screen. See the following table that lists the
parameters and their descriptions.
3. Click OK and then click COMMIT.
Parameter Description
MAC Address Displays the MAC address of the Ethernet interface.
Operational Speed Displays the current operational speed of the Ethernet
interface. The speed can be 1Gbps, 100 Mbps, or
10Mbps.
Operational Tx Mode Displays the current operational transmit mode of the
Ethernet interface. There are 2 types of transmission
modes:
• Half Duplex: Allows one-way transmission at
a time. Only receive or transmit operations
can be performed at once.
• Full Duplex: Allows two-way transmissions
simultaneously.
To Next Page
Loading...