Proxim Tsunami MP-8100 Series - 2 Installation and Initialization

Tsunami MP-8100 Installation and Management Guide 13
2
Installation and Initialization
This chapter describes the steps required to install and mount the MP-8100 Series units, and to align the antenna. If you are
already familiar with this type of product, refer to the Tsunami MP-8100 Quick Installation Guide for streamlined installation
procedures.
This chapter covers the following topics:
• Hardware Overview
• Product Package
• Installation Procedure
– Step 1: Plan for Installation
– Step 2: Choose a Location
– Step 3: Gather Required Tools
– Step 4: Unpack the Product Package
– Step 5: Assemble the Cable
– Step 6: Assemble Mounting Hardware
– Step 7: Mount the Unit
– Step 8: Plug in the Cables
– Step 9: Connect the Antenna (Connectorized Version Only)
– Step 10: Install Surge Protector
– Step 11: Ground the Unit
– Step 12: Power on the Unit
– Step 13: View LEDs
– Step 14: Align the Antenna
• Initialization
– ScanTool
– Setting the IP Address with ScanTool
• Logging in to the Web Interface
• Factory Default Configuration