Installation and Initialization
Tsunami MP-8100 Installation and Management Guide 21
Step 6: Assemble Mounting Hardware
1. Attach the mounting plate (A) using the provided screws and washers (Torque 9 N
.
m/75 in-lbs), such that the unit’s
antenna will be vertically or horizontally polarized when mounted.
2. Attach the extension arm (B) to the mounting piece (A) with the screw, nut, and washers provided, as shown below.
The extension arm gives the device more tilt, letting you adjust for azimuth or elevation over a larger angle.
3. Attach the mounting bracket (C) to the extension arm (B) with the screw, nut, and washers provided.
To Next Page
Loading...