Installation and Initialization
Tsunami MP-8100 Installation and Management Guide 22
4. Tighten all the screws (Torque 15 N
.
m/130 in-lbs).
The following figure shows the full assembly attached to the unit.
Step 7: Mount the Unit
1. To pole-mount, insert screws through bracket (F) and fasten around the pole to bracket (C) and secure them (Torque
11 N
.
m/100 in-lbs). Longer bolts (not supplied) are required for mounting the units to a pole with a diameter larger
than 3 inches.
2. To wall-mount the unit, mount the bracket (C) to a wall using 4 screws (not provided), as shown:
To Next Page
Loading...