Installation and Initialization
Tsunami MP-8100 Installation and Management Guide 19
– Pinout follows 802.3af standard for mid-span devices
See the following steps for installation instructions:
Step 1: Plan for Installation
There are several planning factors to be considered before installing the MP-8100 system. In addition to selecting the
installation site, you should do the following:
Calculate:
• Required RSL and fade margin to achieve availability objectives
• Required path availability
• Anticipated Multi-Path Reflection Points
Determine:
• System Frequency Plan
• Required Antenna Mounting Height to obtain proper Path Clearance
• Required Transmission Line Types and Lengths
Plan for:
• Device’s continuous power consumption needs
• Lightning protection and system grounding
• Hardware mounting
• Cable installation including egress
• Pre-testing equipment (back-to-back test procedure)
Step 2: Choose a Location
To make optimal use of the device, you must find a suitable location to install the hardware. The range of the radio device
largely depends upon the position of the antenna. Proxim recommends you do a site survey, observing the following
requirements, before mounting the hardware.
• The location must allow easy disconnection of power to the radio if necessary.
• Ensure free flow of air around the hardware.
• The radio device must be kept away from vibration and excessive heat.
• The installation must conform to local regulations at all times.
The units are designed to directly mount to a pole. Using the supplied brackets and hardware, you can mount them to a 1.25
inch to 3-inch pole (outside diameter). Longer bolts (not supplied) are required for mounting the units to a larger diameter
pole. Using just one of the pole mounting brackets, you can mount the units to a wall or other flat surface.
CAUTION: Proxim recommends the use of a lightning protector at the building ingress point. One Lightning
Protector is included in the Product Package. Refer to the documentation that comes with the
Lightning Protector for more information and installation instructions.
Step 3: Gather Required Tools
You should have the following tools available before installing the MP-8100 units:
• Phillips (cross-tip) screwdrivers
• Small blade standard screwdriver
• Large blade standard screwdriver
• Wire crimpers (if using connectors that are not pre-made)
• Adjustable 6” wrench
To Next Page
Loading...