Tsunami MP-8100 Installation and Management Guide 127
4.10.3 RIP (Routing Mode Only)
Routing Information Protocol (RIP) is a dynamic routing protocol, which can be used to automatically propagate routing table
information between routers. The unit can be configured in RIPv1, RIPv2, or both while operating in Routing mode.
When a router receives a routing update including changes to an entry, it updates its routing table to reflect the new route.
RIP maintains only the best route to a destination. Therefore, whenever new information provides a better route, the old
route information is replaced.
NOTE: RIP is configurable only when the unit is in Routing Mode and Network Address Translation (NAT) is disabled.
To enable RIP functionality
• Enable RIP status from the drop-down menu. RIP runs on per interface basis.
To configure RIP parameters
1. Click ADVANCED CONFIGURATION > Network > RIP. The RIP screen is displayed as shown below.
S.No. Protocol Support Applications
1 H.323 H.323 ALG Multimedia Conferencing
2 HTTP Port Mapping for
inbound connection
Web Browser
3 TFTP Port Mapping for
inbound connection
Trivial file transfer
4 Telnet Port Mapping for
inbound connection
Remote login
5 IRC Port Mapping for
inbound connection
Chat and file transfer
6 AMANDA Port Mapping for
inbound connection
Backup and archiving
7 FTP FTP ALG File Transfer
8 PPTP PPTP ALG VPN related
9 NETBIOS Port Mapping for
inbound connection
Applications on different
computers can
communicate within a LAN
10 SNMP SNMP ALG Network Management
11 DNS Port Mapping for
inbound connection
Domain Name Service
To Next Page
Loading...