Installation and Initialization
Tsunami MP-8100 Installation and Management Guide 15
2.1.2 Serial Connection
The serial connection is made with an RJ11 to DB9 connector (also referred to as a “dongle”). Connect the RJ11 end to the
unit and connect the serial (DB9) end to your PC to align the antenna and to enter CLI commands.
See the following figure:
Figure 2-2 Serial Components
The connections are as follows:
Recommended Cable
Function Power (DC) and Ethernet connection
Type Cat5e/Cat6, UV-shielded and outdoor-rated
Impedance 100 ohms
Recommended cables STP, 24 AWG, UL rated
Maximum Distance 330 feet / 100 meters
Connector type, device end Shielded RJ45 female, weatherized using weatherproof connector
Connector type, power & Ethernet adapter end Shielded RJ45
D-Shell RJ11
1NC
22
34
4NC
5 1 + 3 + 5
66
7NC
8NC
9NC
To Next Page
Loading...