Tsunami MP-8100 Installation and Management Guide 181
System Name(config-net-ip)# ethernet-ip-table
System Name(config-net-ip-etherip)# index 1 ipaddress <ipaddress>
System Name(config-net-ip-etherip)# index 1 mask <subnet mask>
System Name(config-net-ip-etherip)# index 1 address-type <Address Type>
System Name(config-net-ip-etherip)# default-gateway <IP Gateway>
System Name(config-net-ip)# default-gateway <IP Gateway>
System Name(config-net-ip-etherip)#exit
System Name(config-net-ip)#exit
System Name(config-net)#exit
System Name(config)# commit 1
System Name(config)# reboot 1
6. After the unit reboots, verify the new IP address by reconnecting to the CLI and enter a show configure network
command. Alternatively, you can ping the device from a network computer to confirm that the new IP address has
taken effect.
7. When the proper IP address is set, use the HTTP interface or CLI over Telnet to configure the rest of the unit’s operating
parameters.
8.4.8 RADIUS Authentication Server
If you enabled RADIUS Authentication on the unit, make sure that your network’s RADIUS servers are operational. Otherwise,
clients cannot log in. There are several reasons the authentication server services might be unavailable, here are two typical
things to check:
• Make sure you have the proper RADIUS authentication server information setup configured in the device. Check the
RADIUS Authentication Server’s Shared Secret and Destination Port number (default is 1812; for RADIUS Accounting,
the default is 1813).
• Make sure the RADIUS authentication server RAS setup matches the device.
8.4.9 TFTP Server
The “Trivial File Transfer Protocol” (TFTP) server allows you to transfer files across a network. You can upload the configuration
files from the unit for backup or copying, and you can download configuration files or new firmware. The TFTP software is
located on the installation CD. If a TFTP server is not configured and running, you will not be able to download and upload
software and configuration files to/from the device. Remember that the TFTP server does not have to be local, so long as you
have a valid TFTP IP address. Note that you do not need a TFTP server running unless you want to transfer files to or from the
device.
After the TFTP server is installed:
• Check to see that TFTP is configured to point to the directory containing the device Image.
• Make sure you have the proper TFTP server IP Address, the proper device firmware name, and that the TFTP server is
connected.
• Make sure the TFTP server is configured to both Transmit and Receive files (on the TFTP server’s Security tab), with no
automatic shutdown or time-out (on the Auto Close tab).
To Next Page
Loading...