Tsunami MP-8100 Installation and Management Guide 186
A
Frequency Domains and Channels
Introduction
The Tsunami MP-8100 is available in two SKUs one for US (US) and the Other for World (WD) Markets. Depending on the
SKU, the device is hard programmed at factory to that Regulatory domain. Regulatory domain controls the list of frequency
domains that are available in that SKU. Further each frequency domain will define the country specific retaliatory rules and
frequency bands. This is a configurable option.
The frequency domain can be easily configured using the WEB Interface as it is a drop down list with all the available
domains. When using with CLI/SNMP, care has to be taken to set the domains using a predefined ENUM value. Below is the
list of all available frequency domains in each SKU with their corresponding ENUM value in the braces:
For US SKU
• United States 5GHz (1)
• United States 5.8GHz (2)
• United State 2.4 GHz (3)
For World SKU
• World 5 GHz (4)
• World 4.9 GHz (5)
• World 2.4 GHz (6)
• World 2.3 GHz (7)
• World 2.5 GHz (8)
• Canada 5 GHz (9)
• Europe 5.8 GHz (10)
• Europe 5.4 GHz (11)
• Europe 2.4 GHz (12)
• Russia 5 GHz (13)
• Taiwan 5 GHz (14)
• United States 5GHz (15)
• Canada 5.8GHz (16)
Example: To set WORLD 5GHz as Frequency Domain using CLI
System Name#configure
System Name(config)# system-configure
System Name(config- sysconfig)# frequency-domain ?
Possible completions:
<unitedstatesall(1),unitedstatesadhoc(2),unitedstates2p4(3),worldall(4),w
orld4p9ghz(5),world2p4ghz(6),world2p3ghz(7),world2p5ghz(8),canada5ghz(9),
europe5p8ghz(10),europe5p4ghz(11),europe2p4ghz(12),russia5ghz(13),taiwan5
ghz(14),unitedstates5ghz(15), canada5p8ghz(16)> configure the
Frequency Domain
System Name(config-radio)# interface 1 frequency-domain 4
Note:Changes in Frequency Domain requires Reboot.
To Next Page
Loading...