Installation and Initialization
Tsunami MP-8100 Installation and Management Guide 25
.
Step 12: Power on the Unit
Plug in the power cord into a power outlet after having connected the Power Injector and the Radio device using Cat5e/Cat6
cable. There is no ON/OFF switch on the unit. To disconnect power, unplug the RJ45 connector from the “PWR LAN-OUT”
port on the power injector.
Step 13: View LEDs
When the device is powered on, it performs startup diagnostics. When startup is complete, the LEDs show the unit’s
operational state. The LEDs are available at the unit’s Ethernet connector inside the enclosure. You can see the LEDs through
the ethernet connector. The LEDs will not be visible when the weather sealing caps are installed.
The following table describes the status of LEDs:
LED State Eth1
Wireless LED Power/Ethernet LED
Yellow Power is on & unit detects Reload
signal
Unit is self heating (Cold Start)
Off Radio is not present or failed to
detect
No Power
Blinking Green-Fast Radio is on and wireless link has not
been established yet
Power is on and the Ethernet Eth1 link is down
Blinking Green-Slow NA Bootloader detected no image
Green A wireless link has been established Power is on and the Ethernet link Eth1 is up
LED State Eth2
Wireless LED Power/Ethernet LED
Yellow NA -
Off Normal Operation No Power
Blinking Green-Fast NA Power is on and the Ethernet link Eth2 is down
Blinking Green-Slow NA Bootloader detected no image
To Next Page
Loading...