Installation and Initialization
Tsunami MP-8100 Installation and Management Guide 27
• The range of the average SNR has been limited to values from 5 to 43; therefore, anything over 43 always results in
a short period between beeps and values below 5 always have a long period.
• The Antenna Alignment Display (AAD) CLI command is disabled automatically 30 minutes after it is enabled to
remove the load of extra messages on the wireless interface. The default telnet time-out is 900 seconds (15
minutes). If AAD must run for the entire 30 minutes, change the default telnet time-out value to a value greater
than 30 minutes (greater than 1800 seconds). This restriction is for telnet connections only and not for the serial
interface. The serial interface never times out; however, the AAD command does still time out.
Antenna Alignment Commands
• aad enable local display: Enables display of the local SNR. Local SNR is the SNR measured by the receiver at
the near end.
• aad enable remote display: Enables display of the remote SNR. Remote SNR is the SNR as measured by the
receiver at the far end.
NOTE: You must have a flat blade screw driver to disconnect and pull out the Serial cable from the enclosure after the
antenna alignment is done. After withdrawing the cables, seal the ethernet port carefully to avoid water seepage.
To Next Page
Loading...