Tsunami MP-8100 Installation and Management Guide 42
Active Channel This will display the current active channel on which wireless
interface is operating. If you have enabled the auto channel
selection option or if the device moves to a different channel
because of radar detection, then this field displays the current
operating channel.
Tx Rate This parameter represents the transmission data rate of the
device. Desired rate can be selected from the list of available Tx
rates.
NOTE: Configure the appropriate data rate based on the
signal level.
Network Name It is the name given to a network so that an BSU and an SU can
mutually authenticate. SU can register to BSU, only if it has the
same Network Name. The Network Name can be 2 to 32
characters in length.
Legacy Mode Select Enable or Disable. When Legacy Mode is enabled, it helps
the device to interoperate with the legacy products of the
Tsunami MP.11 family: MP.11 5054 series, 5012 series, 2454
series, etc.
Ethernet IP Configuration
By default, the device is configured to operate in Bridge Mode. The parameters in this section vary depending
on the device’s operating mode, i.e., Bridge or Router.
IP Address Type • Select Static if you want to assign a static IP address to the
unit. Use this setting if you do not have a DHCP server or if you
want to manually configure the IP settings.
• Select Dynamic to have the device run in DHCP client mode,
which gets an IP address automatically from a DHCP server
over the network.
NOTE: The default Address Type is Static.
When the unit is in Bridge mode, only one IP address is required.
This IP address also can be changed with ScanTool (See Setting
the IP Address with ScanTool.
IP Address This parameter is configurable only if the IP Address Assignment
Type is set to Static. The default IP Address for device is
169.254.128.132.
Subnet Mask The mask of the subnet to which the unit is connected (the
default subnet mask is 255.255.255.0). This parameter is
configurable only if the IP Address Assignment Type is set to
Static.
Parameter Description
To Next Page
Loading...