Tsunami MP-8100 Installation and Management Guide 55
NOTE: When you modify wireless parameters and click COMMIT, it may result in brief interruption of service.
Parameter Descriptions
Channel Bandwidth This parameter specifies the channel bandwidth. By default, it is
set to 20 MHz. 40 MHz can be selected for higher throughput.
Auto Channel Selection (ACS) Enable or disable the Auto Channel Selection for wireless
interface. If ACS is enabled on the BSU, it scans all the channels
and selects the best channel at the startup. If ACS is enabled on
the SU, the SU continuously scans all the channels till it connects
to a BSU.
By default, ACS is disabled on BSU and enabled on SU.
Preferred Channel Select a channel from the drop-down menu if you want to
operate the device in that specific channel.
NOTE: Preferred channel cannot be configured when
ACS is enabled. If DFS is active, the device will
automatically pick a new channel when radar
interference is detected.
Active Channel This displays the current operating channel on which wireless
interface is operating.
NOTE: Active Channel can be different from Preferred
Channel if radar interface is detected.
Channel Wait Time Specifies the maximum time the device waits to begin operation
on the selected channel. By default, this value is 60 seconds and
ranges from 0 to 120 second.
To Next Page
Loading...
