Tsunami MP-8100 Installation and Management Guide 60
Modifying the Guard Interval, Data Streams, Tx Antenna Status and Rx Antenna Status will reset the Tx Rate to default.
Guard Interval Possible values for Guard interval are 800 nSec and
400 nSec. 400 nSec is valid only for 40 MHz channel
bandwidth.
Data Streams MIMO radio uses multiple antennas for transmitting
and receiving the data. These data streams specify the
number of data streams over the air transmitted or
received in parallel.
• Data streams “1-Longer Range” uses a single
flow of the signals on the antennas.
• Data streams “2-Higher Throughput” uses
double flow of the signals on the antennas in
parallel.
Tx Antenna Status This parameter allows the user to specify the antenna
to be used for data transmission. Selecting the
respective antenna number checkbox specifies radio to
use that specific antenna for data transmission.
Rx Antennas Status This parameter allows the user to specify the antenna
to be used for data reception. Selecting the respective
antenna number checkbox specifies radio to use that
specific antenna for data reception.
Parameter Description
To Next Page
Loading...