Tsunami MP-8100 Installation and Management Guide 64
Field Description
Profile Name Enter the security profile name.
Encryption Type Select an option from None, WEP, TKIP or AES-CCM for the Encryption Type.
1. None - If this option is selected, no encryption will be applied to the wireless link frames.
2. AES-CCM - This option represents CCM Protocol with AES Cipher restricted to 128 bits.
• Key 1/Key 2/Key 3/Key 4: Enter 16 ASCII Characters or 32 Hex Digits.
• Transmit Key: Select one out of the four keys described above as the default transmit
key with which the frames are encrypted.
3. WEP - This option represents the WEP Encryption type, which uses RC4 stream cipher for
confidentiality and CRC-32 for integrity. The supported key lengths for WEP are 5/13/16
ASCII Characters or 10/26/32 Hexadecimal digits.
• Key1 / Key 2 / Key 3 / key 4: Enter 5/13/16 ASCII Characters or 10/26/32
Hexadecimal digits.
• Transmit Key: Select one out of the four keys described above as the default transmit
key with which the frames are encrypted.
4. TKIP - This option represents the TKIP Encryption type, which uses RC4 stream cipher for
confidentiality. TKIP provides per-packet key mixing, a message integrity check and a
re-keying mechanism. It uses 128-bit keys for encryption. The key length for TKIP is 16
ASCII characters or 32 Hexdecimal digits.
• Key1 / Key 2 / Key 3 / key 4: Enter 16 ASCII Characters or 32 Hexadecimal digits.
• Transmit Key: Select one out of the four keys described above as the default transmit
key with which the frames are encrypted.
NOTE:
• All four Keys (Key1, Key2, Key3, Key4) have to be of same length and same type
i.e., all four Keys should be either ASCII Characters or Hexadecimal digits.
• Transmit Key can be any one of the four keys, provided all the four keys in BSU and
SU are the same.
• WEP/TKIP Encryption Types are supported only in legacy Modes.
• The encryption mode should not be selected as AES-CCM while the device is
interoperating with legacy Tsunami MP.11 family devices which include 954-R,
2454-R, 4954-R, 5054-Series, and 5012-Series.
Entry status Select Enable/Disable to enable or disable the status of the security profile.
Network Secret Enter the WORP Protocol Secret Key used for authenticating the SU with the BSU.
NOTE: The BSU ans SU should have same Network Secret.
To Next Page
Loading...