Tsunami MP-8100 Installation and Management Guide 75
QoS PIR TCP/UDP Port Configuration
1. Click ADVANCED CONFIGURATION > QoS > PIR List > TCP/UDP Port Entries. Three predefined TCP/UDP Port
Entries are displayed. You can configure maximum 256 entries. Start Port, End Port combination should be unique.
This TCP/UDP Port entry can be referred in the PIR Rule’s Source or Destination TCP/UDP Port Classification. TCP/UDP
Port Entry referred by any PIR rule can not be deleted.
Figure 4-16 QoS PIR TCP/UDP Port Entries
2. Add a New PIR TCP/UDP Port Entry.
a. Click Add to add a new entry. The following screen appears for configuring the IP Address entry details.
Figure 4-17 QoS PIR TCP/UDP Port Add Entry
b. Provide the Start Port, End Port, Entry Status details and click Add. Comment field can be used to identify when
this particular entry is referred in PIR Rule/QoS Class.
To Next Page
Loading...
