Proxim Tsunami MP-8100 Series - Page 79

Advanced Configuration
Tsunami MP-8100 Installation and Management Guide 79
Parameter Description
Rule Name This parameter specifies the Name of the Packet Identification Rule
(PIR) and can have a length of 1-32 characters.
ToS Rule This parameter is used to enable/disable TOS rule. Enter the values
for the following to specify the ToS-related configuration:
ToS Low
ToS High
ToS Mask
Ether Priority Rule This parameters is used to enable or disable 802.1p priority rule.
Enter the values for the following to specify 802.1p priority
configuration:
Priority Low
Priority High
VLAN Rule This parameters allows to enable or disable VLAN rule. Enter the
VLAN ID when the VLAN rule is enabled.
PPPoE Encapsulation This parameter is used to classify PPPoE traffic.
NOTE:
• Enabling/disabling PPPoE Configuration will
automatically disable Ether Type Rule. User can
configure it again by enabling Ether Type Rule.
• When PPPoE Encapsulation is enabled, incoming
packet will be checked again Ether value “0x8864” and
look for PPPoE Protocol Id value “0x0021”(IP Protocol)
by default. User can modify the PPPoE Protocol Id. All
other classification rules which are specified in the PIR
rule will work only if the PPPoE Protocol Id is “0021”.
• Ether Value is not valid when PPPoE Encapsulation is
enabled.