Tsunami MP-8100 Installation and Management Guide 97
To conf ig ure VLA N
• Click ADVANCED CONFIGURATION > VLAN.
Figure 4-38 Configuring VLAN
VLAN parameters can be classified into two types: System-related VLAN parameters and Interface-related VLAN parameters.
1. System-related parameters: These parameters are applicable to the whole device. The following parameters are the
System-related VLAN parameters.
a. VLAN Status: Selecting the VLAN Status checkbox enables the VLAN Status on the device. To update all VLAN
related parameters, VLAN status should be enabled.
NOTE: By default, the VLAN status is disabled.
b. Management VLAN ID: This parameter is used to configure the Management VLAN ID. This option is available
when Management VLAN ID is configured. The management stations must tag the management frames sent to
the device with the management VLAN ID specified in the device. The device will tag all the management frames
from the device with the specified management VLAN and priority.
NOTE:
• If the Management VLAN ID is -1, only untagged frames can access the device.
• Before setting the Management VLAN ID from 1 to 4094, make sure that the management platform or host is a
member of the same VLAN; or else, your access to the device will be lost.
c. Management VLAN Priority: This parameter is used to set IEEE 802.1p priority for the frames. The priority value
ranges from 0 to 7. By default, it is set to 0 (zero).
2. Interface-related VLAN parameters: The device supports configuring VLAN modes for Ethernet interface. The
wireless interface is always in Transparent Mode.
To Next Page
Loading...