PRV Audio DSP2.8X - Page 6

10 11
OUT1: ON
GRAPH EQ: ON
MUTE ALL (ENTER)
GRAPH EQ: ON
ON ALL [ENTER]
GRAPH EQ: ON
• Mute
The outputs can be switched individually on and o quickly by holding down the
HOTKEY key that corresponds to the output. The LED color indicates the status
of the output.
In the “MUTE” screen, you can sll
turn o and on all the output channels
simultaneously using the ENCODER go to
the output eld and select “ALL-ENTER”
or “ALL-ENTER ON”. Then fast touch on
ENCODER. You can also turn the input
graphic equalizer on or o.
BLUE LIGHT: OUTPUT ON / RED LIGHT: OUTPUT OFF (MUTE)
MAIN MENU
Graph EQ Presets
MAIN MENU
XOVER Presets
GRAPH EQ PRESETS
Loudness
XOVER PRESETS
OUT 1 <- FLAT
• Graphic Equalization Presets
The DSP2.8X oers 12 graphic equalizaon presets that are selected from the
“GRAPH EQ PRESETS ” in the main menu:
• FLAT • LOUDNESS • BASSBOOST • MID BASS • TREBLE BOOST
• POWERFUL • ELECTRONIC • ROCK • HIP HOP • POP
• VOCAL • PANCADAO (Heavy Beat)
• Crossover Presets
The processor oers 11 crossover presets that are selected from the “XOVER
PRESETS ” in the main menu, in this way it is possible to congure the frequency
cut of each output more quickly:
• SUBW1 • SUBW2 • SUBW3 • WOOFER1 • WOOFER2 • WOOFER3
• DRIVER1 • DRIVER2 • DRIVER3 • TWEETER • FLAT
COPY CHANNEL
Source: OUT1
COPY CHANNEL
Destination: OUT2
COPY CANNEL
NO [YES]
• Copy Channel
This funcon allows you to copy all audio sengs from one output channel to
another. The copied funcons are: parametric output equalizer, roung, crossover,
alignment, phase inversion, limiter, gain and mute.
I. Select an SOURCE output channel using the
HOTKEY hotkeys or by turning the ENCODER,
fasten ENCODER;
II. Select a DESTINATION output channel
using the HOTKEY shortcut keys or by turning
the ENCODER, fasten ENCODER;
III. A conrmaon message will appear. If
conrmed, as output channels from ORIGIN
to the DESTINATION output channel,
overwring as the DESTINATION output
channel.
• Save / Load / Factory Reset
The DSP2.8X has four memory slots available for saving personalized sengs,
accessed via the “SAVE” funcon. Saved sengs can be named with tles up
to 15-characters long. Besides the memory space available to the user, there
is autosave, where all parameters and sengs are saved in a separate working
To load previously saved sengs use
the “LOAD” funcon. This funcon also
allows the factory presents to be loaded
via the “DEFAULT” memory.
SAVE MEMORY1
Memory1
LOAD
Default
FACTORY RESET
NO [YES]
memory. Or rather, if there is a drop in
power or the product is turned o during
conguraon, the sengs will not be lost.
This funcon cannot be disabled.
If you want to restore all of the DSP2.8X factory sengs, simultaneously hold down the
HOTKEY shortcut keys for outputs 1, 2 and 3 while turning on the device.
This procedure will erase all internal sengs and saves.