This quick start guide provides the user very basic information required to make the E10
controller pulse solenoid valves and to make changes to the time and pressure settings. The
user is referred to the E10 manual for detailed connection and setup information and all
safety and warning instructions. The E10 should only be installed by a suitably qualified
person and all local electrical standards must be observed.
Top Board Layout
Bottom Board Layout
LCD Screen
Three Button
Interface
Output Relays
Modbus RTU and/or
extension cards
Solenoid
Valve
Outputs
110/240
VAC
Input
24VDC Input
Or Output
Fuse (AC
version)
24VDC connections
for tube cleaning valves
Quick Start Guide
E10 Master Controller
To Next Page
Need help?
General
