02
|
PULLMAN PC4.0
PC4.0 PULLMAN
|
03
IMPORTANT SAFETY INSTRUCTIONS
Congratulations on your purchase of your new Pullman vacuum cleaner.
There are many useful features built into your cleaner and we recommend
that you carefully read this instruction book so that you may take best
advantage of them.
BEFORE YOU BEGIN
This product must be operated in accordance with these instructions and used
only for the removal of DRY dirt and dust. This cleaner is not designed for the
collection of vitreous building materials including particle board construction
products and similar products such as wood/fibres, sand, cement, fillers, fibre
glass etc. The pick-up of these materials may be harmful to your cleaner and
will void the manufacturer’s warranty.
Safety reminders and taking care of your Pullman cleaner, PLEASE READ
THESE INSTRUCTIONS THOROUGHLY. This will ensure you obtain full
benefit from your new cleaner. Keep this instruction book in a handy place
for future reference.
IMPORTANT
Always switch the cleaner off and remove the plug from the electricity supply
before cleaning your appliance, when not in use, or attempting any maintenance
task. The cleaner must only be connected to an AC supply a the voltage shown
on the rating plate. This cleaner should only be used for its intended purpose as
described in these instructions.
NEVER OPERATE THE VACUUM CLEANER WITHOUT FILTERS FITTED.
DO NOT pick up hard or sharp objects, matches, hot ashes, cigarette ends
or similar items.
DO NOT pick up flammable liquids such as cleaning fluids, petrol etc.,
or use in the presence of such vapors.
DO NOT use your cleaner out of doors or on any wet surface or for
WET pick-up.
DO NOT use the vacuum cleaner with wet hands or with bare feet.
DO NOT put any objects into openings.
DO NOT use with any opening blocked; keep free of dust, lint, hair
and anything that may reduce airflow.
DO NOT allow children or the infirm to operate this appliance without
supervision. It must not be used on people or animals. Do not allow to be
used as a toy.
NEVER run over the supply cord, or use the cord as a carry handle, or pull
across sharp edges. Keep cord away from heated surfaces.
Always disconnect the cleaner from the power outlet by pulling out the plug
directly, NEVER by pulling on the supply cord.
If using an extension cord please make sure that it is of an approved type and
that it is fully extended. Failure to do so could cause your cleaner to overheat
and damage it.
FAULTS
Do not continue to use the appliance if it appears to be faulty or the supply
cord is damaged. If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified person in order to
avoid a hazard.
If a fault cannot be rectified, please return to the point of purchase.
If damaged, return the cleaner for repair by an authorised Pullman Service
Centre in order to avoid a safety hazard.
Consult the trouble shooting guide in this manual if your vacuum cleaner fails
to operate properly. Contact an authorised service agent if the problem persists.
AFTER USE
Switch the cleaner off and remove the plug from the electricity supply.
Always switch off and remove the plug before attaching any accessories
or cleaning the appliance.
PROTECTING THE ENVIRONMENT
When you have upacked the unit, do not simply throw the packing into the
household waste. Take them to an appropriate collecting point for the recycling.
PULLMAN
Model PC4.0
220-240V 50Hz
1200W Max.
App. No: NSW22794
! N127
To Next Page
Loading...
